To reset your Apple MagSafe, you can follow these steps:
1. Check the setup animation: When you first connect your MagSafe wallet to your iPhone, there should be a setup animation that appears on your iPhone’s screen. If the animation disappeared or didn’t appear at all, there might be an issue.
2. Put your iPhone to sleep: To start troubleshooting, press the side button on your iPhone to put it to sleep. This will turn off the screen and lock your device.
3. Wake and unlock your iPhone: After a few seconds, wake your iPhone by pressing the side button again. Then, unlock your iPhone using Face ID, Touch ID, or your passcode.
4. Place the wallet onto the back of your iPhone: Take your MagSafe wallet and place it onto the back of your iPhone. Make sure it is aligned properly with the MagSafe connection area.
5. Wait for up to 15 seconds: Now, give it some time. Wait for up to 15 seconds to see if the setup animation reappears. During this time, your iPhone and the MagSafe wallet will establish a connection.
6. Check for the setup animation: If everything goes well, the setup animation should reappear on your iPhone’s screen. This indicates that the MagSafe wallet is successfully connected and ready to be set up.
If the setup animation still doesn’t appear after following these steps, there might be a deeper issue with either your iPhone or the MagSafe wallet itself. In such cases, it is recommended to reach out to Apple support for further assistance.
It’s worth noting that personal experiences may vary, and these steps are based on general troubleshooting guidelines provided by Apple. If you encounter any specific error messages or unusual behavior during the process, it’s advisable to consult official Apple resources or contact their support team for more accurate and personalized assistance.