To reset your Wansview camera model W6, please follow these steps:
1. Locate the reset button on your camera. It is typically a small pinhole button located on the back or bottom of the camera.
2. Using a small pin or paperclip, press and hold the reset button for about 5 seconds. Make sure to apply gentle pressure and hold it steadily.
3. After holding the reset button for 5 seconds, you should see the yellow light on the camera start flashing quickly. This indicates that the reset process has started.
4. Continue holding the reset button until you hear the camera say “reset is successful.” This may take about 5 to 10 seconds.
5. Once you hear the confirmation message, release the reset button and wait for about a minute. During this time, the camera will go through the reset process.
6. After approximately one minute, you should see the camera’s lights start flashing alternately between green and yellow. This indicates that the camera has been successfully reset.
7. Now, you can proceed to reconnect your camera. Follow the instructions provided by the camera’s manufacturer to connect it to your desired network or device.
By following these steps, you should be able to reset your Wansview camera model W6. It’s important to note that the exact process may vary slightly depending on the specific model and firmware version of your camera. If you encounter any issues or if the reset process doesn’t work as expected, it’s recommended to refer to the camera’s user manual or contact Wansview support for further assistance.