To install the Britax Boulevard car seat in the middle seat of your vehicle, follow these steps:
1. Locate and remove the tether strap from its storage compartment. The tether strap is a long, adjustable strap with a hook at one end.
2. Place the tether strap over the back of the car seat, making sure it is positioned securely and not twisted.
3. Place the car seat in the middle seat of your vehicle. Ensure that the seat is facing forward and is flat on the seat of the vehicle.
4. Adjust the position of the car seat so that it is centered on the middle seat. The car seat should not extend more than 3 inches over the edge of the vehicle seat.
5. Fasten the seat belt across the car seat. Make sure the seat belt is routed through the appropriate belt path, as indicated in the car seat’s instruction manual.
6. Buckle the seat belt and pull it tight to ensure a secure fit. Check that the seat belt is not twisted and that it is properly locked in place.
7. Attach the tether strap to the tether anchor in your vehicle. The tether anchor is typically located on the back of the vehicle seat or on the floor behind the seat.
8. Adjust the length of the tether strap as needed to ensure a snug fit. The tether strap should be tight and secure, with minimal movement.
9. Double-check that the car seat is properly installed by giving it a firm shake from side to side and front to back. The car seat should not move more than an inch in any direction.
10. Once you are confident that the car seat is securely installed, adjust the harness straps to fit your child snugly. The shoulder straps should be at or just below your child’s shoulders, and the chest clip should be positioned at armpit level.
Remember to consult the car seat’s instruction manual for specific installation guidelines and any additional safety considerations. It’s important to install the car seat correctly to ensure the utmost safety for your child while traveling.