To get your Vizio sound bar out of demo mode, you need to follow a few steps. Here’s a detailed guide on how to do it:
1. Locate the Input and Bluetooth buttons on your Vizio sound bar. These buttons are usually located on the top or front panel of the sound bar.
2. Press and hold both the Input and Bluetooth buttons simultaneously for about 10 seconds. Make sure to hold them down until you see all of the LEDs on the sound bar flash four times.
3. If the LEDs only flash once instead of four times, it means that the demo mode is still enabled. In this case, repeat the previous step and hold the buttons down for another 10 seconds until you see the LEDs flash four times.
4. After the LEDs have flashed four times, release the Input and Bluetooth buttons. This indicates that the demo mode has been successfully disabled.
5. To confirm that the demo mode has been disabled, check if the sound bar functions normally. You should be able to change inputs, connect to Bluetooth devices, and adjust the volume without any restrictions.
It’s important to note that the exact steps may vary depending on the specific model of your Vizio sound bar. If you’re unsure about the button placement or the process, you can refer to the user manual that came with your sound bar. The manual should have detailed instructions on how to disable the demo mode.
If you don’t have the manual or are unable to find the specific instructions for your model, you can also try reaching out to Vizio customer support for assistance. They will be able to guide you through the process and provide any additional troubleshooting steps if needed.
Disabling the demo mode on your Vizio sound bar can be done by pressing and holding the Input and Bluetooth buttons for 10 seconds until all of the LEDs flash four times. If the LEDs only flash once, repeat the steps to ensure the demo mode is disabled.