To charge your Ring Base Station, follow these simple steps:
1. Start by plugging the power adapter from your Ring Alarm Pro into the Power Pack’s orange Power In port. This will provide the necessary power to charge the base station.
2. Wait for a few seconds to allow the Power Pack LED light to turn green. When the light is solid green, it indicates that the Power Pack is charging.
3. Now, it’s time to connect the Power Pack to your Alarm Pro. Use the short, double-sided USB-C cable provided with the Power Pack for this purpose. Plug one end of the cable into the Power Pack’s USB-C port and the other end into the USB-C port on your Alarm Pro.
4. Once you have connected the Power Pack to your Alarm Pro, it will start charging the base station. You can leave it plugged in for as long as needed to ensure a full charge.
5. While the base station is charging, you can check the LED light on the Power Pack to monitor the charging status. A solid green light indicates that the base station is charging, while a solid red light means that it’s not charging or there might be an issue with the connection.
6. It’s important to note that the charging time may vary depending on the current battery level of your base station and the capacity of the Power Pack. It’s recommended to leave it plugged in for a few hours to ensure a complete charge.
7. Once the base station is fully charged, you can unplug the Power Pack from your Alarm Pro and disconnect the USB-C cable. Your base station is now ready for use.
Remember to keep the Power Pack and USB-C cable in a safe place for future use or if you need to charge the base station again.
I hope these instructions help you charge your Ring Base Station successfully. If you have any further questions or need assistance, feel free to ask.