Why is my Keurig duo blinking?
If your Keurig duo is blinking, it is likely due to an issue with the magnet inside the water reservoir. When this magnet becomes dislodged or misaligned, it can cause the brewer to turn off unexpectedly between brews and result in the red light flashing continuously.
To troubleshoot this problem, you will need to remove the water reservoir and then place it back securely into the brewer. Here’s how to do it:
1. Turn off your Keurig duo and unplug it from the power source for safety.
2. Remove the water reservoir by lifting it straight up and away from the brewer. Be careful not to spill any water.
3. Inspect the bottom of the water reservoir and the area where it sits in the brewer. Look for the magnet, which is usually located near the center or towards one side of the reservoir base.
4. Make sure the magnet is properly aligned and not stuck to the reservoir’s base. If it is misaligned or detached, gently reposition it so that it is in the correct position.
5. Check the area in the brewer where the magnet interacts with the sensor. Ensure that there is no debris or residue that may impair the connection between the magnet and the sensor.
6. Carefully place the water reservoir back into the brewer, ensuring it is aligned properly and fully seated. You should feel a slight click when it is securely in place.
7. Plug in your Keurig duo and turn it on. The blinking light should stop, and the brewer should function normally.
If the blinking light persists after reseating the water reservoir, there may be another issue at play. In such cases, it is recommended to refer to the user manual or contact Keurig customer support for further assistance. They will be able to guide you through additional troubleshooting steps or advise on any necessary repairs.
The blinking light on your Keurig duo is most likely caused by a dislodged magnet inside the water reservoir. By removing and reseating the reservoir, you can often resolve this issue and get your brewer working properly again.